Effect of Electric Current Variations on Spot Welding of Stainless Steel and Aluminum Microstructures

Authors

  • Ahmadil Ahmadil Author

DOI:

https://doi.org/10.46365/jmio.v2i02.434

Keywords:

Aluminum, Electric Current, Microstructure, Stainless Steel, Spot Welding

Abstract

Welding technology has been developed to join dissimilar metals, but the performance in the field of welding still poses some problems as a result of the different properties of the metals. By adjusting the amount of electric current given, nuggets with microstructures will be produced which have maximum bond strength. The purpose of this study was to determine the effect of variations in electric current on spot welding on the microstructure of stainless steel and aluminum. The electric current variations used are 60 A, 70 A, and 80 A with a welding time of 4 seconds. The test material consisted of stainless steel with a thickness of 1.2 mm and aluminum with a thickness of 0.9 mm. Data analysis was carried out through metallographic analysis. The higher the electric current used, the higher the heat input. If the heat input given is high enough, the cooling rate will be slower so that the grains grow larger and tend to form a dendrite phase which in turn causes a decrease in the strength of the weld. The microstructure obtained in spot welding with an electric current of 70 A and a welding time of 4 seconds has a fine grain shape to provide the most optimal strength compared to other welding parameters.

Downloads

Published

2022-01-18